VORTEX Ultra-Durable Coating Remover

Specially formulated for fast penetration and emulsification of coatings for low cost removal.

Intended Use

  • Specially formulated for fast penetration and emulsification of coatings for low cost removal.

Product Features

  • Ready to Use
  • Fast Penetration
  • Convenient Packaging

Physical Properties

  • Flash Point – n/a
  • Viscosity – Low Viscosity
  • Color – Clear
  • Boiling Point – 212 degrees F°
  • Fragrances – Butyl Odor
  • pH – 8.3

Application Instructions

Apply onto the coating using a microfiber applicator or blended wet mop. apply at a rate of 160 sq. ft. per gallon (400 sq. ft. per 2.5 gallon container). Apply liberal amounts of vortex to prevent evaporation. It maybe necessary to add more vortex as it penetrates the coating. Allow the vortex to soak for thirty minutes and penetrate the coating. once penetration has occurred agitate and scrub the coating with a standard floor machine with an aggressive brush. Some areas may require a flat edge scraper (where the scrub brush doesn’t reach). Using a floor squeegee, move the material into a pile and pick-up with a commercial wet/dry vacuum. Continue this process until all of the coating and stripping solution has been removed. Flood rinse with clear water and agitate with a standard floor machine using an 80 grit screen. When screening is done pick up the solution with a commercial wet/dry vacuum, damp mop with clear water to neutralize the surface. Caution: more than one rinsing cycle may be necessary. Check ph of floor before applying another coat.
© West Coast Chemical 2024